ECM1900

I2C Peripherals

There are a couple of I2C peripherals that you can access via the PS_I2C1. The following components and addresses are listed below.

SIGNAL	FPGA PIN
SCL	`A28 (PS_MIO16)`
SDA	`C29 (PS_MIO17)`

Voltage, Current, and Temperature Monitors

Four Analog Devices LTC2991 provide voltage, current, and temperature monitoring for the ECM1900. Device sensor inputs are connected as shown in the table below. +xV_SRC and +xV connections measure the voltage across a 5mOhm resistor for current sensing. For more information see the Device Sensors page.

DEVICE I2C ADDRESS	U35 `1001 000x`	U37 `1001 001x`	U40 `1001 010x`	U46 `1001 011x`
V1	+1.8V_SRC	+1.2V_DDR_SRC	+3.3V_SRC	+5V_SRC
V2	+1.8V	+1.2V_DDR	+3.3V	+5V
V3	+1.8V	+1.2V	VCCO_28_SRC	VCCO_87_88_SRC
V4	–	+1.2V_MGTAVTT	VCCO_28	VCCO_87_88
V5	+0.9V_VCCINT_VCU	+1.2V_MGTAVTT_SRC	VCCO_28	VCCO_87_88
V6	+0.9V_MGTAVCC	+1.2V_MGTAVTT	VCCO_67	VCCO_68
V7	+0.9V_MGTAVCC_SRC	FPGA_DXP	VCCO_67_SRC	VCCO_68_SRC
V8	+0.9V_MGTAVCC	FPGA_DXN	VCCO_67	VCCO_68

Clock Generator (Si5341)

A Silicon Labs Si5341B programmable clock generator provides nine independent LVDS clock pairs to the FPGA. For more information, visit the Clock Generator page.

USB Type-C Channel Configuration

A TUSB320 (U4) handles communication and configuration of the USB-C CC lines. I2C access is provided for this device, but the default operation of the device is sufficient for most use cases.

DEVICE	DESIGNATOR	I2C ADDRESS	FUNCTION
Texas Instruments TUSB320	U4	`1000 111x`	USB Type-C Channel Configuration

FPGA Core Supply Regulator

The FPGA core supply is provided by a programmable switching regulator. This device has been configured at the factory. The PMBus interface may be used to read out voltage and current monitor values.

Changing any settings on this device could cause permanent damage to the ECM1900 and is not covered by our warranty.

DEVICE	DESIGNATOR	I2C ADDRESS	FUNCTION
Intel EM2140	U24	`1100 110x`	FPGA core supply regulator