There are four LEDs on the XEM7360 in addition to the power LED.  Each is wired directly to the FPGA as shown in the table below.

LEDFPGA PIN
D0T24
D1T25
D2R25
D3P26

The LED anodes are connected to a pull-up resistor to +3.3 V and the cathodes wired directly to the FPGA on Bank 13 with a bank I/O voltage of 3.3 V.  To turn ON an LED, the FPGA pin should be at logic ‘0’.  To turn OFF an LED, the FPGA pin should be at logic ‘1’.