Specifications
| Host Interface | USB 3.0 Type C, SuperSpeed FrontPanel Support |
| FPGA | 5CEFA4F23C7N |
| Memory | 512 MiByte DDR3, 16-bit wide data interface |
| NV Memory | 16 MiB System Flash 16 MiB FPGA Flash |
| Oscillator | 100 MHz |
| FPGA I/O Voltage | See Powering the ZEM5310 |
| MINIMUM | TYPICAL | MAXIMUM | UNITS | |
|---|---|---|---|---|
| DC Input | +4.5 | +5.0 | +5.5 | VDC |
| DC Input Ripple | – | – | 50 | mVp-p |
| Operating Temperature | 0 | – | +70 | ºC |
| Storage Temperature | -50 | 0 | +100 | ºC |
| Weight | 24 | grams | ||
| Oscillator Frequency | 100 | MHz | ||
| Oscillator Freq. Stability | ±50 | ppm | ||
| Oscillator Period Jitter | 2.5 | ps RMS |
PCB Footprint
The ZEM5310 PCB is 75mm x 50mm with four mounting holes (M2 metric screws) spaced as shown in the figures below. These mounting holes are electrically isolated from all signals on the ZEM5310. The two connectors (USB and DC power) overhang the PCB by approximately 1.3mm in order to accommodate mounting within an enclosure.
The ZEM5310 has two high-density 0.8mm connectors providing access to 106 I/O including two CLKOUT and four CLK signals as well as multiple bank I/O voltages.
Mechanical Drawing
The mechanical drawing below may be used for enclosure or mounting hardware design. 3D Models are also available in SolidWorks, STEP, and IGES formats.
Mating Board Diagram
Use the mating diagram below to orient and design peripheral mating hardware. Note that this is a top-down view and mates to the bottom of the ZEM5310. This design is realized in Altium CAD drawings in the corresponding breakout board which are available through Pins Downloads.
For Samtec connector details, drawings, models, and landing patterns, please visit Samtec’s website.
