Page tree
Skip to end of metadata
Go to start of metadata

Important Lifecycle Information

Unlike our integration modules, breakout boards are not intended for production integration. We reserve the right to change dimensions and functionality of this board at any time and may not necessarily have the previous version available for purchase.

The BRKD-ACV is a basic "breakout board" / reference design which can be used to evaluate or transition to the FOMD-ACV. It includes the following features:

  • +5 VDC input connector with over-voltage protection
  • Four DIP-programmable voltage regulators for VCCIO1, VCCIO2, VCCPD1, and VCCPD2
  • Two 2x10 2-mm header locations
  • Four 2x20 2-mm header locations
  • Four Digilent PMOD connectors
  • Two Pushbuttons
  • JTAG Connector

Please visit the Pins reference for the FOMD-ACV for pin mapping details. Full Altium schematics and PCB layout are available through Pins Downloads.

Voltage Regulators

PWR1 (S3) controls VCCIO1 and VCCPD1. PWR2 (S4) controls VCCIO2 and VCCPD2.

Switches 1 - 6 of each DIP switch control VCCIOx. When in the ON location, they contribute the corresponding voltage to the total. When in the OFF location, they contribute 0mV to the total. 500mV is always contributed to the total. Therefore, the output voltage is 500mV plus the sum of all ON switches. For example, to select 2.5v, set the switches accordingly:

  • 4, 6 = ON
  • 1, 2, 3, 5 = OFF
  • Output = 500mV + 400mV + 1600mV = 2.5V
SwitchOFFON
10mV50mV
20mV100mV
30mV200mV
40mV400mV
50mV800mV
60mV1600mV
7VCCPDx = 2.5vVCCPDx = 3.3v
8DisabledEnabled

Note: Switch 4 is incorrectly labeled as "0.5V" in the PCB silkscreen.

FPGA Configuration Mode Select

Ten resistors are used to set the value of the five MSEL configuration pin select pins on the FPGA. The default configuration of these resistors is shown below. The yellow entries are not loaded in the factory default configuration. The existing resistors may be removed and the opposing resistors loaded to change the state of the configuration mode. The default selects Active-Serial with Fast Power-On-Reset (MSEL4-0 = 10010).

MSELPull-up (VCCPGM)Pull-down (DGND)
MSEL4R1, 0ΩR8, 10kΩ
MSEL3R2, 10kΩR9, 0Ω
MSEL2R3, 10kΩR10, 0Ω
MSEL1R4, 0ΩR11, 10kΩ
MSEL0R5, 10kΩR12, 0Ω

  • No labels